Anycubic Kobra Plus

The Anycubic Kobra Plus is an FDM 3D printer from Anycubic with a 300 x 300 x 350 mm build volume.

Calibration

• Establish a clean mechanical baseline before any slicer tuning.

Action: Power the printer off, then inspect the motion system from top to bottom: verify that the gantry is square, both Z leadscrews move freely, the X-axis carriage has no binding, the belts are tensioned evenly, and the bed carriage travels without gritty spots.

Common defects

The provided sources do not document a formal recall, but they do reveal several practical limitations and failure modes that matter in real use.

• Power headroom is relatively tight.

Symptoms: The machine heats normally but leaves little electrical margin, and users may become concerned about sustained load during warm-up. One review explicitly notes that the printer draws about 330 W during heating and that this is close to a 350 W power-supply rating.