The Anet E10 is an FDM 3D printer from Anet with a 300 x 300 x 400 mm build volume.
The Anet E10 is an FDM 3D printer from Anet with a 300 x 300 x 400 mm build volume.
Action: Power off the printer, inspect the aluminum frame, and verify that all vertical uprights, crossmembers, and gantry supports are fully seated and tightened. Check that the bed carriage rolls smoothly, the X gantry is not visibly twisted, and both Z lead screws turn with similar resistance by hand.
The E10 is not “broken by design,” but the sources consistently show that it is a machine where mechanical tolerances, cooling geometry, and manual calibration quality strongly determine outcomes. Its most common issues are therefore less about a single catastrophic defect and more about a cluster of predictable weaknesses.
| Manufacturer | Anet |
|---|---|
| Technology | FDM |
| Class | hobby |
| Build volume | 300 x 300 x 400 mm |
| Auto levelling | no |
| Compatible materials | pla, petg, tpu, matte-pla, silk-pla, glow-pla, pva, wood |
| Manufacturer | Anet |
|---|---|
| Technology | FDM |
| Class | hobby |
| Build volume | 300 x 300 x 400 mm |
| Auto levelling | no |
same class and kinematics, close in price within 30 percent
| Model | Class | Build volume |
|---|---|---|
| Anet E10 (this) | hobby | 300 x 300 x 400 mm |
| Alfawise U20 | hobby | 300 x 300 x 400 mm |
| Anet E12 | hobby | 300 x 300 x 400 mm |
| Anet E16 | hobby | 300 x 300 x 400 mm |
| Material | Nozzle temperature | Bed temperature |
|---|---|---|
| PLA | 210-230 °C | 55-65 °C |
| PETG | 230-265 °C | 70-85 °C |
| TPU | 220-240 °C | 35-55 °C |
| PVA | 220-240 °C | 45-65 °C |