Skip to content
EduFacturing

Goofoo Tiny

The Goofoo Tiny is an FDM 3D printer from Goofoo with a 100 x 100 x 100 mm build volume.

The Goofoo Tiny is an FDM 3D printer from Goofoo with a 100 x 100 x 100 mm build volume.

Specifications

The Goofoo Tiny (manufactured by Xiamen Goofoo Technology) is a compact, lightweight FDM (Fused Deposition Modeling) 3D printer designed primarily for classrooms, early STEM education, young makers, and budget-conscious hobbyists. The machine features an open frame design with a single-arm cantilever motion system, placing safety, ease of operation, and portability at the core of its architecture.

  • Hotend and Extruder: The printer features a direct-drive extruder mounted directly on the carriage, which shortens the filament path. The hotend is capped in the firmware at a maximum operating temperature of 200 °C.

Calibration

Achieving high-quality prints on the Goofoo Tiny requires precise calibration to compensate for its cantilever kinematics and unheated build plate.

  • Vertical Z-Axis Column Alignment (Perpendicularity Check)

Due to the single-column cantilever design, the vertical Z-axis profile can become misaligned relative to the base plate during shipping or assembly. Use a machinist's square to check if the Z-axis profile forms a strict 90-degree angle with the steel base.

Common defects

  • Hardware defects and mechanical weaknesses
  • Cantilever Sag (X-axis Droop): Over time, the Z-axis carriage rollers wear down, causing the right end of the cantilever arm to sag by 1-2 mm. This results in poor adhesion on the right side of the bed. Adjusting the eccentric nuts on the Z-axis carriage is required to eliminate this play.
  • Rapid Guide Bushing Wear: To reduce costs, the printer uses brass slide bushings on the X and Y axes instead of linear ball bearings.

What it is used for

Best use-cases:

  • STEM Classrooms and Libraries: Excellent for introducing students to additive manufacturing. Its low power consumption, quiet operation, and covered belts make it safe for group learning environments.
ManufacturerGoofoo
TechnologyFDM
Classhobby
Build volume100 x 100 x 100 mm
Auto levellingno
Compatible materialspla, petg, tpu, matte-pla, silk-pla, glow-pla, pva, wood

Specifications

ManufacturerGoofoo
TechnologyFDM
Classhobby
Auto levellingno

Compared with 3 similar

same class and kinematics, close in price within 30 percent

ModelClassBuild volume
Goofoo Tiny (this)hobby
101Herohobby
3DI D300hobby300 x 300 x 300 mm
Abax PRi3hobby230 x 230 x 200 mm

Compatible materials and print settings

MaterialNozzle temperatureBed temperature
PLA210-230 °C55-65 °C
PETG230-265 °C70-85 °C
TPU220-240 °C35-55 °C
PVA220-240 °C45-65 °C
Matte PLASilk PLAGlow PLAWood Composite