gMax 1.5 Plus Dual Extruder

The gMax 1.5 Plus Dual Extruder is an FDM 3D printer from gCreate with a 406 x 406 x 304 mm build volume.

Calibration

• Establish a clean mechanical baseline before any extrusion tuning.

Action: Place the printer on a rigid, level surface with enough clearance for the full 16-inch-class motion envelope, then inspect the frame for square, fastener tightness, belt path alignment, and carriage smoothness. Confirm that the build plate, if installed, is seated flat and that the Z system rises and falls without binding across the full travel range.

Common defects

The provided sources do not contain an official recall notice, a formal EOL bulletin, or a manufacturer-issued defect list for the gCreate gMax 1.5 Plus Dual Extruder, so the notes below focus on documented limitations and high-probability engineering risks inferred from the available material and from the machine’s described design class.

• No built-in camera or smart monitoring stack is documented..