Cubicon Style Plus-A15

The Cubicon Style Plus-A15 is an FDM 3D printer from Cubicon with a 150 x 150 x 150 mm build volume.

Calibration

• Confirm installation, leveling reference, and enclosure condition before any print
• Action: Place the printer on a rigid, flat surface and verify that all four feet are stable. Use the machine’s top-mounted level reference if present, and check that the chassis is not rocking. Close the enclosure fully, inspect door alignment, and make sure no debris is trapped on the bed rails, build plate, or wiper path.

Common defects

The provided sources do not contain a formal Cubicon Style Plus-A15 recall notice, EOL bulletin, or firmware advisory, so the defect analysis below is based on documented behavior of the Cubicon Style family and on issues that follow logically from the printer’s verified design choices .

• Over-adhesion on the coated heated bed
• Symptoms: Parts bond strongly during printing and can be difficult to remove if the bed is still warm or if first-layer squish is too aggressive.