Creality Ender-3 S1 Plus

The Creality Ender-3 S1 Plus is an FDM 3D printer from Creality with a 220 x 220 x 250 mm build volume.

Calibration

• Bed Leveling with BLTouch

Step: Begin by accessing the printer’s menu and navigating to the "Auto Leveling" option. Ensure the BLTouch sensor is properly mounted and the firmware is updated to the latest version. Run the auto-leveling routine, which will perform a grid-based scan of the build plate. The printer will adjust the Z-axis height at each grid point to compensate for bed irregularities. After the scan, manually inspect the first layer by printing a small test cube.

Common defects

• Hardware defects and mechanical weaknesses

Symptom: The BLTouch sensor may fail to trigger consistently, leading to incorrect Z-axis offsets.

Cause: The BLTouch’s solenoid can become misaligned or damaged due to physical impacts or dust accumulation.

Solution: Clean the BLTouch probe with compressed air and realign the solenoid. If the issue persists, replace the BLTouch with a higher-quality model like the BLTouch V3.

What it is used for

The Creality Ender-3 S1 Plus is optimized for hobbyists, educators, and small-scale prototyping due to its affordability, ease of use, and robust feature set. Below is a detailed analysis of its strengths and limitations:

What it prints well

• PLA and PETG: The printer excels at printing standard thermoplastics like PLA and PETG.