Skip to content Skip to content
EduFacturing
Tech

Cold Spray: Solid-State Metal Deposition Without Melting

Cold Spray: Solid-State Metal Deposition Without Melting

In 2025–2026, Cold Spray (CS) additive manufacturing has gained significant traction for metal deposition applications where thermal damage must be avoided. Unlike every other metal AM process, Cold Spray does not melt the feedstock. Instead, metal particles are accelerated to 300–1200 m/s in a supersonic gas jet and bond to the substrate through solid-state plastic deformation upon impact.


Process Physics

How Do Particles Bond Without Melting?

At high-velocity impact, kinetic energy converts into:

  1. Adiabatic Plastic Deformation: Both particle and substrate deform locally, disrupting surface oxide films.
  2. Surface Self-Cleaning: Clean metallic surfaces (oxide-free) come into direct atomic contact.
  3. Solid-State Bonding: Metallurgical bonds form through atomic diffusion at the interface, similar to explosive welding.

Critical Velocity: Each metal has a minimum impact velocity ($V_{cr}$) below which bonding does not occur:

Metal $V_{cr}$ (m/s) Typical Process Gas
Aluminum 600 – 700 Air or $N_2$
Copper 500 – 600 $N_2$ or He
Titanium 700 – 900 He (Helium)
Steel 600 – 800 $N_2$ or He
Inconel 700 – 900 He

Interactive Filament Selector

Answer 3 quick questions and find the optimal material for your project.

1. What are the mechanical requirements for the part?


Pros and Cons

Pros:

  • No Melting = No HAZ: Critical for sensitive substrates.
  • No Oxidation: Process occurs well below melting point.
  • Minimal Residual Stress: CS generates compressive (beneficial) residual stresses.
  • High Deposition Rates: 5–50 kg/hr (significantly higher than laser DED).

Cons:

  • Porosity: 1–5% porosity (higher than PBF).
  • Rough Surface: Requires CNC finishing.
  • Expensive Helium: Titanium and superalloys require costly helium gas.
  • Limited Geometric Complexity: Cannot create internal cavities.

FAQ

Q: Is Cold Spray truly “cold”?
A:
Relatively: gas is heated to 300–800°C to increase velocity, but particles remain below melting point. Substrate heating is minimal (typically < 100°C above ambient).
Q: Can Cold Spray replace thermal spray (HVOF)?
A:
For certain applications: yes. CS produces denser coatings with less oxidation. But for ceramic coatings (e.g., $ZrO_2$ thermal barriers), HVOF remains irreplaceable.
Q: What is the particle size?
A:
Typically 5–50 μm. Smaller particles accelerate more easily but are more expensive to produce.

Cold Spray: Solid-State Metal Deposition Without Melting Calculator

Interactive optimization calculator.

Optimal Value
0.00

The full picture

This article is one page from The Big Book of 3D Printing: 704 illustrated pages covering every technology, material and fix in one reference.

Read it on Kindle →

Engineer, author of The Big Book of 3D Printing and additive manufacturing expert

We use cookies. Essential ones make the site work.

Want Google's AI to give you accurate 3D-printing answers? Add EduFacturing as a Preferred Source (opens Google, add “edufacturing.com”).