Skip to content Skip to content
EduFacturing

Why Your 3D Model Fails? 5 Common Reasons

Half of all 3D printing “failures” do not come from the printer. They come from the model: walls that are too thin, overhangs without supports, poor orientation, missing tolerances. These 5 rules are a filter to apply EVERY time before you slice, and they save hours and material.

~38%Failures caused by the model
5Key checks
2 minReview time
€15+Saved per failure avoided
5 rules
01

Minimum wall thickness

On FDM with a 0.4 mm nozzle: at least 0.8 mm (two perimeters). For durable parts, 1.2 to 1.6 mm. On SLA: at least 0.5 mm for vertical walls and at least 1.0 mm for horizontal ones. Any thinner and it breaks during handling.

02

The 45° rule

Overhangs under 45° from vertical print without supports on FDM. Beyond 45° means supports are mandatory, or the part needs reorienting. SLA safely handles up to 30°. Test the angles with an overhang test.

03

Tolerances for assemblies

0.2 mm clearance for a loose fit, 0,1 mm for a tight fit, 0,3-0,4 mm for sliding parts. Always test with a sample before printing the final set.

04

Orientation is everything

Layers are weakest across the load. Rotate the model so the forces run parallel to the layers. CNC Kitchen’s tests show a 2 to 4 times difference in strength.

05

Rounded corners

Sharp external corners concentrate stress and crack on impact. A fillet of at least 1 mm on every load-bearing corner. External corners are cosmetic; internal ones are structurally critical.

!

A common mistake

“I will print at 100% infill, then it will be strong.” No. Above 40% infill you add a marginal 5 to 10% in strength but double the time and material. Better: 20 to 30% gyroid, 3 to 4 perimeters and good orientation. Every time.

A full model review before printing

Run through this list for every model, especially for functional parts that will carry load:

The list, 90 seconds

  1. Wall thickness the slicer marks them in red if they fall below two perimeters
  2. Review the supports if they exceed 30% of the volume, reorient the model
  3. Stress test press the model with a finger in your mind; which areas will break?
  4. Hole tolerances add 0.1 to 0.2 mm to the diameters so they fit after printing
  5. Branding and text raised relief works better on FDM; recessed relief on SLA
i

Expert tip

Before you slice, open Prototyping checklist. 40+ checks spread across 7 phases (design, material, slicing, printing, post-processing, testing, iteration), so nothing slips through.

What comes next

Once the model passes review, it is time to calibrate the printer. For FDM use AutoTowers and First Layer Tuner. For choosing a material, Material comparison. The full picture: The Big Book of 3D Printing.

The full picture

This article is one page from The Big Book of 3D Printing: 704 illustrated pages covering every technology, material and fix in one reference.

Read it on Kindle →

Engineer, author of The Big Book of 3D Printing and additive manufacturing expert

We use cookies. Essential ones make the site work.

Want Google's AI to give you accurate 3D-printing answers? Add EduFacturing as a Preferred Source (opens Google, add “edufacturing.com”).